Material: Zinc die-cast ZnAI4Cu1. Shaft angle = 90°. Bores machined. The bevel gears only run as a pair at the stated ratio. In the torque calculation of zinc-die-cast bevel gears only the root strength was considered. Due to the material properties these gears are only to a limited extend suitable for continuous operation. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears of the same module and ratio. At ratio 1:1, you need two pieces of the same number of teeth. At ratio uneven 1:1, you need two pieces with a different number of teeth of the same ratio.
Transmission | 1:1 (16/16) |
---|---|
Module | 2,0 |
No. of Teeth | 16 |
da (mm) | 34,6 |
d (mm) | 32 |
ND (mm) | 23 |
NL (mm) | 10 |
L1 (mm) | 19,2 |
L (mm) | 21,3 |
b (mm) | 9,6 |
BH9 (mm) | 10 |
E (mm) | 30,0 |
Admissible MD (Ncm) | 110 |
Weight (g) | 52 |
Corresponding Counter Wheel (Article-No.) | 35900700 |