Material: Zinc die-cast ZnAI4Cu1. Shaft angle = 90°. Bores machined. The bevel gears only run as a pair at the stated ratio. In the torque calculation of zinc-die-cast bevel gears only the root strength was considered. Due to the material properties these gears are only to a limited extend suitable for continuous operation. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears of the same module and ratio. At ratio 1:1, you need two pieces of the same number of teeth. At ratio uneven 1:1, you need two pieces with a different number of teeth of the same ratio.
| Transmission | 1:1 (16/16) |
|---|---|
| Module | 3,0 |
| No. of Teeth | 16 |
| da (mm) | 52,3 |
| d (mm) | 48 |
| ND (mm) | 30 |
| NL (mm) | 13 |
| L1 (mm) | 26,0 |
| L (mm) | 29,3 |
| b (mm) | 14 |
| BH9 (mm) | 14 |
| E (mm) | 42,5 |
| Admissible MD (Ncm) | 380 |
| Weight (g) | 146 |
| Corresponding Counter Wheel (Article-No.) | 35940700 |
