Material: Zinc die-cast ZnAI4Cu1. Shaft angle = 90°. Bores machined. The bevel gears only run as a pair at the stated ratio. In the torque calculation of zinc-die-cast bevel gears only the root strength was considered. Due to the material properties these gears are only to a limited extend suitable for continuous operation. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears of the same module and ratio. At ratio 1:1, you need two pieces of the same number of teeth. At ratio uneven 1:1, you need two pieces with a different number of teeth of the same ratio.
| Transmission | 1:1 (16/16) |
|---|---|
| Module | 3,5 |
| No. of Teeth | 16 |
| da (mm) | 61,4 |
| d (mm) | 56 |
| ND (mm) | 34 |
| NL (mm) | 14 |
| L1 (mm) | 29,2 |
| L (mm) | 33,2 |
| b (mm) | 15,5 |
| BH9 (mm) | 16 |
| E (mm) | 49,4 |
| Admissible MD (Ncm) | 580 |
| Weight (g) | 228 |
| Corresponding Counter Wheel (Article-No.) | 35950700 |
