Material: up to module 2: 11SMn30+SH (1.0715). From module 2.5: C45. Tooth quality 8 modelled on DIN 3967 (from module 2). Up to module 5 with crowned, milled teeth. From module 6 with planed teeth. Not hardened – not lapped. Shaft angle = 90º. The bevel gears only run as a pair at the stated ratio and at the same module. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears, with the same module and the same number of teeth.
Transmission (i) | 1:1 (24/24) |
---|---|
Module | 0,5 |
No. of Teeth | 24 |
da (mm) | 12,7 |
d (mm) | 12 |
ND (mm) | 8 |
NL (mm) | 4 |
L1 (mm) | 6,4 |
L (mm) | 7,0 |
S (mm) | 5,0 |
b (mm) | 3 |
BH7 (mm) | 4 |
E (mm) | 10,7 |
Admissible MD (Nm) | 0,018 |
Weight (g) | 3 |
Corresponding Counter Wheel (Article-No.) | 36021500 |