Material: up to module 2: 11SMn30+SH (1.0715). From module 2.5: C45. Tooth quality 8 modelled on DIN 3967 (from module 2). Up to module 5 with crowned, milled teeth. From module 6 with planed teeth. Not hardened – not lapped. Shaft angle = 90º. The bevel gears only run as a pair at the stated ratio and at the same module. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears, with the same module and the same number of teeth.
| Transmission (i) | 1:1 (30/30) |
|---|---|
| Module | 0,5 |
| No. of Teeth | 30 |
| da (mm) | 15,7 |
| d (mm) | 15 |
| ND (mm) | 10 |
| NL (mm) | 4 |
| L1 (mm) | 7,5 |
| L (mm) | 8,5 |
| S (mm) | 6,6 |
| b (mm) | 3 |
| BH7 (mm) | 4 |
| E (mm) | 13,7 |
| Admissible MD (Nm) | 0,032 |
| Weight (g) | 4 |
| Corresponding Counter Wheel (Article-No.) | 36022000 |
