Material: up to module 2: 11SMn30+SH (1.0715). From module 2.5: C45. Tooth quality 8 modelled on DIN 3967 (from module 2). Up to module 5 with crowned, milled teeth. From module 6 with planed teeth. Not hardened – not lapped. Shaft angle = 90º. The bevel gears only run as a pair at the stated ratio and at the same module. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears, with the same module and the same number of teeth.
Transmission (i) | 1:1 (40/40) |
---|---|
Module | 1,0 |
No. of Teeth | 40 |
da (mm) | 41,4 |
d (mm) | 40 |
ND (mm) | 30 |
NL (mm) | 10 |
L1 (mm) | 18 |
L (mm) | 19,8 |
S (mm) | 15,7 |
b (mm) | 6 |
BH7 (mm) | 8 |
E (mm) | 35 |
Admissible MD (Nm) | 0,55 |
Weight (g) | 111 |
Corresponding Counter Wheel (Article-No.) | 36052600 |