Material: up to module 2: 11SMn30+SH (1.0715). From module 2.5: C45. Tooth quality 8 modelled on DIN 3967 (from module 2). With crowned, milled teeth. Not hardened – not lapped. Shaft angle = 90º. The bevel gears only run as a pair at the stated ratio and at the same module. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears of the same module, with a different number of teeth of the same ratio.
| Transmission (i) | 2,5:1 (16/40) |
|---|---|
| Module | 2,5 |
| No. of Teeth | 16 |
| da (mm) | 44,8 |
| d (mm) | 40 |
| ND (mm) | 30 |
| NL (mm) | 13 |
| L1 (mm) | 32 |
| L (mm) | 34,1 |
| S (mm) | 15,9 |
| b (mm) | 20 |
| BH7 (mm) | 10 |
| E (mm) | 65 |
| Admissible MD (Nm) | 5,0 |
| Weight (g) | 180 |
| Corresponding Counter Wheel (Article-No.) | 36116500 |
