Material: up to module 2: 11SMn30+SH (1.0715). From module 2.5: C45. Tooth quality 8 modelled on DIN 3967 (from module 2). Up to module 5 with crowned, milled teeth. From module 6 with planed teeth. Not hardened – not lapped. Shaft angle = 90º. The bevel gears only run as a pair at the stated ratio and at the same module. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears, with the same module and the same number of teeth.
| Transmission (i) | 1:1 (18/18) |
|---|---|
| Module | 3,0 |
| No. of Teeth | 18 |
| da (mm) | 58,4 |
| d (mm) | 54 |
| ND (mm) | 40 |
| NL (mm) | 10 |
| L1 (mm) | 25 |
| L (mm) | 28,1 |
| S (mm) | 17,2 |
| b (mm) | 17 |
| BH7 (mm) | 10 |
| E (mm) | 42 |
| Admissible MD (Nm) | 6,4 |
| Weight (g) | 280 |
| Corresponding Counter Wheel (Article-No.) | 36140900 |
