Material: Steel. For fixing a hub (e.g. drive wheel, rotor or similar) on a shaft. For high torques. Self-centering. Axial offset during mounting (can be compensated by correct positioning). Tolerances, Surfaces Ø-tolerance for shafts and hubs +/- 0.04mm. Mounting It is essential to degrease the shaft and hub. Install clamping sets nearly completely degreased. Tighten the nut with a torque wrench with hexagon socket to the torque TA.
| d (mm) | 15 |
|---|---|
| D (mm) | 26 |
| L (mm) | 29 |
| L1 (mm) | 16 |
| B (mm) | 5 |
| Transmissible Torque T (Nm) | 126 |
| Transmissible Axial Force Fax (kN) | 17 |
| Surface Pressure Hub (N/mm²) | 107 |
| Wrench Width SW (mm) | 22 |
| Tightening Torque TA (Nm) | 66 |
| Weight (g) | 62 |
