Material: Steel. Clamping bush for medium high torques; not self-centering. Fit: Shaft h8. Hub H8. Surface roughness Rz max. 12.5 µm. Mounting: Slightly oil the clamping set before mounting, do not use molibdenum disulphide or grease. Tighten the screws evenly and crosswise in several steps. Demounting: Due to the large cone angle, the clamping set releases on its own after the screws have been fully unfastened. There are three larger threads cut into the front ring, which serve to remove this ring. Ts - Fastening Torque T - Transmittable Torque F - Transmittable Axial Force P - Surface Pressure onto Hub
| d (mm) | 15 |
|---|---|
| D (mm) | 42 |
| L (mm) | 20 |
| L2 (mm) | 26 |
| Transmissible Torque T (Nm) | 200 |
| Transmissible Axial Force Fax (kN) | 27 |
| Surface Pressure Hub P (N/mm²) | 101 |
| Bolt Size M (mm) | 8 x M6 |
| Tightening Torque TA (Nm) | 15 |
| Weight (kg) | 0,18 |
