Material: Stainless steel 1.4401 (AISI 316). Clamping bush for lower torques; not self-centering. Fit: Shaft h8, Hub H8. Surface roughness Rz max. 16 µm. Mounting: Slightly oil the clamping set before mounting, do not use molibdenum disulphide or grease. Tighten the screws evenly and crosswise in several steps. Demounting: Due to the cone angle, the clamping set is usually released once all screws have been fully unfastened. There a three large threads cut into the front ring, which serve to remove this ring. Ts - Fastening Torque T - Transmittable Torque F - Transmittable Axial Force P - Surface Pressure onto Hub
| d (mm) | 55 |
|---|---|
| D (mm) | 85 |
| L (mm) | 24 |
| L2 (mm) | 32 |
| Transferable Torque T (Nm) | 1400 |
| Axial Force Fax (kN) | 43 |
| Surface Pressure Shaft PW (N/mm²) | 106 |
| Surface Pressure Hub PN (N/mm²) | 68 |
| Clamping Bolts DIN 912 (N. x Typ) | 14 x M8 |
| Torque TA (Nm) | 18 |
| Weight (kg) | 0,65 |
